RUUD RAWL-091CAZ

Commercial Series Split System Air Conditioners

• Galvanized steel cabinet and base pan with durable powder-coat paint finish
• Stamped louver panels offer 100% protection for condenser coil
• Scroll compressor mounted on rubber grommets and hermetically sealed with
  internal high temperature protection and durable insulation on motor windings
• Crankcase heaters help prevent refrigerant migration to the compressor
• Condenser coils constructed with aluminum fins mechanically bonded to copper tubes
• Pressure-sensitive, fan-cycling low ambient control allows operation of units down to 0°F (-17.8°C)
• High and low pressure controls
• Service valves standard on liquid and suction lines
• Step-down type transformer from line to 24V
• Contactor operates the compressor and condenser fans
• Lug for field connection of ground wire
• All units are run-tested at the factory
• Units ship with a holding charge of nitrogen
• Liquid line filter-drier is shipped with each unit for field installation
• AHRI Certified
• ISO 9001:2008 Certified
• cULus Listed
• Limited warranty
• 5-Year limited warranty on compressor
• 1-Year limited warranty on parts

R-410A RAWL Commercial Series High Efficiency 6.5 to 7.5 Ton Single-Stage Air Conditioner

• High-gloss paint finish and fastening screws are capable of
  withstanding a 1,000-hour salt spray test per ASTM B117
• All access panels can be opened or removed
  without affecting structural strength of the unit
• Control box with separation between line voltages
  located in top corner of cabinet for easy service access
• Compressor and other refrigerant controls are accessible through
  removable panel without affecting normal operation of unit
• Direct drive, single-phase, permanently-lubricated PSC condenser
  fan motors are mounted on removable top panels, bringing the
  motor out and exposing the entire condenser coil for cleaning
• Compressors have an internal pressure relief assembly and
  a separate compressor compartment for easy service access
• External wrap-around crankcase heater
• All coil assemblies are leak-tested up to 450 psig internal pressure
• Field sweat joints are made external of the unit and located close to the ground
• Time delay control ensures that compressor will remain off for 5 minutes after power or thermostat interruption